Warm audio Reamper Guitar Preamp
The Warm Audio REAMPER is the missing link between your equipment and your creativity! It allows you to adapt the levels and impedances of your equipment, so that your guitar amps, pedals, synthesizers and studio equipment work together optimally with your digital audio interface.
With it, you'll be able to record high-quality guitar tracks directly from the instrument into your DAW, then re-inject them later into your pedals or amp, respecting timbre and playing dynamics. You'll be able to make sound adjustments at your leisure after the recording, or use your equipment for recordings received from a remote operator.
The REAMPER allows you to integrate any studio equipment into your guitar chain, as well as any guitar effect in your software or with your electronic instruments (synths, B.A.R., etc.).
It features a built-in power attenuator for recording tube amps up to 50 W (8 Ω impedance) without using a loudspeaker, for silent recording.
- Two channels: independent signal paths for instrument preamp and reamp
- Switchable instrument input stage: discrete JFET or JFET op-amp
- Custom CineMag transformer isolation on each signal path (inputs & outputs)
- Compatible with passive and active instruments, keyboards and pedals
- Maximum instrument input level: +18 dBu (6 VRMS)
- Instrument input impedance: variable from 100 kΩ to 1 MΩ
- Phase inversion & ground/lift per channel
- Speaker input with direct output
- Power soak: 8 ohms, 50 watts max.
- Continuous reamp output level control for attenuation or gain
- Balanced line-level inputs/outputs on XLR and 6.35 mm jack (no phantom powering required)
- Reamp output level: continuous gain attenuation
- Fully active circuit with ultra-low-noise design
- Universal internal AC power supply
- Dimensions (mm): 297 x 162x 107
- Weight : 1.63 Kg
- Euroguitar Referenz : 123113
